Official VNISH Firmware for Antminer S9 S9i S9j

2023-07-10 09:18| 来源: 网络整理| 查看: 265

Air-cooled overclocking capability up to 19 TH/s

Possibility of overclocking on immersion cooling up to 22 TH/s

DEV FEE - 1,8%

If you see a message when changing the BITMAIN firmware: can not find signature

This means that your hardware is running 2019 BITMAIN firmware, which has overwrite protection, 2018 firmware does not have this protection.

If you have BITMAIN firmware installed in June 2019 and earlier, then you can remove protection using the “signature” file and then download our firmware, if you have firmware on July 31, 2019, you can remove protection using the “signature_31july” file and then download our firmware or use an SD card (all files are posted on the site and instructions). You can see the firmware version in the section System - file system version If you see other messages when changing the BITMAIN firmware or the old firmware remains after flashing, then there is a possibility that your ASIC is infected with a virus and it has blocked the ability to upgrade to any other firmware. If during the process of flashing via an SD card you see that 2 lamps (green and red) are lit on the control board and do not blink, then most likely your control board is infected with the ANTBUILD virus, you must use a special ANTBUILD RECOVERY image to block the virus (the instruction is included in the file ). We recommend that you always change the default root password to any other and disable the ssh port, this can be done in bulk using our firmware.

【本文地址】

公司简介

联系我们